Digital multifunctional cable detection of Comprehensive Machine
Solution to live cable routing problems cannot be solved at present
You can find the buried cable jacketing damage to ground short circuit and open - circuit fault
Can be recognition required cable in multi-charged cables
Configuration rechargeable batteries, may completed all the tests without electricity
Find the path of the live cable
You can easily solve the paths find problem in the live cable. Put the coupling clamp to the under test cable, Transmitter coupling signals by coupling clamp on target cable, Path along the cable can receive the signal applied from the transmitter. Such method can detect the cable length is not less than 3 km. The receiver can detect the 50Hz frequency signals from the live cable, this method to distinguish the live cable and the disconnected cables is very useful. In this way, does not need to use transmitter.
Blind testing of underground cables
In some cases, Operator cannot close to the cable to connect directly or using coupling clamp, you can use the built-in induction antenna of transmitter to send output signal, Signal will induction to the measured underground cables for locating exploration, This method to detect Cable Depth will not less than 2 meters.
Find Buried cable fault
UTC20 can be applied step voltage method to determine the buried cable fault of ground insulation less than 2MΩ. Signal strength method can also be used to determine open and short cable fault. UTC20 cable tester has changed the traditional concept of cable fault location, without high voltage test equipment, without the use of AC power, no analysis of waveforms, Connection of simple and straightforward, A look that will be used.
Identification of live cables
Coupling the emissions clamp of transmitter on the cable, couple the receiver clamp on the cable exposure of the other side, At this point the strength of the signal can be determine which one is the applied signal cable.(This method requires a special clamp for receiver.)
FEATURES AND BENEFITS
One-handed operation, the thumb control of all operations
Arrow indicates the path direction
Voice prompts and signal strength indicator
One Touch depth measurement
Manual or automatic gain control
Automatically match the transmitter output power
Both receiver and transmitter battery indicator
May choose a variety appropriate frequency
50/60Hz wire positioning mode
Transmitter automatic test insulation resistance
Simple operation, no training can be mastered
Specifications
Way of working:
Peak method, valley method, A-frame method
Cable routing:
Direct / Coupling / Induction
Cable Identification:
Direct Connect (power cut) / coupling (has power)
Power Supply:
Rechargeable Batteries
Operating Freq:
Low freq, Mid Freq, Hi freq, RF, 50Hz
Clamp Config:
Disconnected cable: 1 clamp / Live cable: 2 clamps
Accuracy:
Depth: +/- (5% H +10) ㎝
Point of failure: +/-15 ㎝
Recognition Rate:
100%
Depth of Probing:
Direct: 5m / Coupling: 3m
Rangeof FaultResistance:
≤2MΩ
Size:
Receiver: 700x 110 x 94㎝
Transmitter: 320 x160 x130 ㎝
Weight:
Receiver: 2.3kg / Transmitter: 3.6kg
Basic Configuration: Transmitter, Receiver, Coupling clamp for Trans., A-frame
Optional Equipment: Coupling clamp for recerver, Car charge
